12 other products in the same category:
Reservoirs are used in the chemical, food, pharmaceutical, wastewater (waterworks, treatment plants) and other technological facilities. Tanks are made in different shapes according to needs. Tanks for special purposes of storage or transport of hazardous substances are made with a special design - double-walled tank.
Orientation:
horizontal, vertical, at the request of the client.
Bottom:...
Range: DN50 to DN600.
- Knife Gate Valve on/off or regulation with rising stem.
- Molded monobloc body
-Unidirectional water tightness: Flow direction indicated on the body with an arrow.
- Installation between flanges ISO PN10.
- Small retention zone.
- Gate with a beveled cutting edge guided in the body with little backlash.
- Guaranteed closure, without risk of blockage.
- Standard polished...
• Stainless steel spindle with rolled thread
• Flange connection according to EN 1092-2; (DIN 2501) pressure PN10; PN16
• Product in accordance with EN 13774
• Packing cork protected against dirt penetration
• Epoxy coating at least 250 microns in accordance with EN 14901 GSK RAL certificate
• Low-friction double-spindle bearing that works horizontally and vertically
• Sealing cork...
1. Compact magnetic filter for boilers
2. Body construction in polyamide PA66 + 33% Glass Fiver
3. Cap construction in polyamide PA66 + 33% Glass Fiver
4. Stainless steel filter AISI 304, 800 microns
5. EPDM PEROX as a hydraulic seal
6. Magnetic element Neodymium RE35 11.000 Gauss.
7. Brass ball valve acc/ UNE-EN 12165
8. Brass connection fitting acc/ UNE-EN 12165
9. Maximum working pressure 3...
Safety shower for emergency decontamination and washbasin for rinsing the eyes.
Safety shower is used in facilities, rooms where chemicals, aggressive liquids are present and there is a possibility of spraying, spillage of a person with a dangerous liquid, acid or base. High quality safety shower. Consists of a shower and nozzles for rinsing the eyes with a sink. Activation via pull lever and...
DN x ESP: 16 x 2.7mm - L: 4m
DN x ESP: 20 x 3.4mm - L: 4m
DN x ESP: 25 x 4.2mm - L: 4m
DN x ESP: 32 x 5.4mm - L: 4.0m
DN x ESP: 40 x 6.7mm - L: 4.0m
DN x ESP 50 x 8.4 mm - L 4.0m
DN x ESP 63 x 10.5 mm - L 4.0m
DN x ESP 75 x 12.5 mm - L 4.0m
DN x ESP 90 x 15 mm - L 4.0m
DN x ESP 110 x 18.3 mm - L 4.0m
DN x ESP 125 x 20.8 mm - L 4.0m
DN x ESP 160 x 26.6 mm - L 4.0m
- The housing and cover are made of 1.4301 stainless steel (AISI 304).
- NBR / EPDM valve circumferential seal according to ISO 1629
- Replaceable seal on the cover that prevents backflow.
- Detachable connections (screws, washers and nuts) that connect the elements are made of stainless steel.
- Nominal connection diameters in accordance with PN-EN ISO 6708.
- The valve designation meets...
error Your review appreciation cannot be sent