

PN 16 full bore. Forged brass UNE-EN 12165. “RAC-GE” air tight system for connection to pipe. Working temp.: -10ºC to 90 ºC. Applicable for the connection of low, medium and high density polyethylene pipe.
Dimensions:
PE20xPE20
PE25xPE25
PE32XPE32
PE40XPE40
PE50XPE50
PE63XPE63
Trusted client
Trusted delivery
16 other products in the same category:
Check valve offers a feed-through flow rate of 5,000 l/h (for concrete basins/tanks - 4000l/h for geomembrane basins) for a pressure loss (groundwater pressure or gas pressure needed for opening the valve) of 60 mbar (60 mm head).
WORKING CONDITIONS Maximum working pressure: 25 bar Maximum working temperature: +4°C / +110°C Epoxy coating RAL 5015 250 microns thickness - WRAS
Advantages of Ductile Iron Pipes - Inherent resistance of ductile iron adainst corrosionalong with improvement of this resistance via various coatings - Appropriate resistance againts pressures such as water hammer and external pressure like traffic loads and etc. -Suitable for use in loose ground with high level of subterranean water - Resistance against electrical currents due to use of...
Application Air release valve intended for use at water lines - for air release and aeration of the pipelines. Working conditions: temp. up +70°C
1. Check valve. 2. Brass construction acc/ UNE-EN 12165. 3. Thread ends gas (BSP) female acc/ ISO 228/1. 4. Working temperature from -20ºC to 100ºC. 5. Suitable for domestic water services, heating on air-conditioning plants and compressed air systems. 6. It can be fitted in horizontal, vertical or oblique position. 7. With inlet strainer. 8. NBR sealing (rubber) 65 shore. 9. Stainless steel...
APPLICATION - Reduction of mechanical and thermal stresse and related systems : pumps, compressors, actuators. -Absorption of lateral movements (30 mm and 60 mm). reduction of vibration and noise. Fluid: fluids subjected to high temperatures and pressures such as: steam, thermal oil, hot water, chemicals etc. GENERAL CHARACTERISTICS Range : from DN 25 to DN300 (MVT 30mm : -20/+10 mm axial)...
error Your review appreciation cannot be sent