16 other products in the same category:
• Stainless steel spindle with rolled thread
• Flange connection according to EN 1092-2; (DIN 2501) pressure PN10; PN16
• Product in accordance with EN 13774
• Packing cork protected against dirt penetration
• Epoxy coating at least 250 microns in accordance with EN 14901 GSK RAL certificate
• Low-friction double-spindle bearing that works horizontally and vertically
• Sealing cork...
Ductile iron cover and wedge EN-GJS 400-15
• Fully borehole valve
• NBR fully vulcanized wedge
• Use of a sliding element with low friction
• Wedge nut made of forged brass - replaceable
• Stainless steel spindle with rolled thread
• Low-friction double-spindle bearing that works horizontally and vertically
• Sealing cork made of sealing spindle, protected against contact with the...
Use:
Gas filters type PL 7310 (inclined flow) and type PL 7320 (straight flow) are intended for filtering natural gas (liquid group 1 in accordance with Directive 2014/68 / EU). Filters can be used in overhead installations in vertical or horizontal pipelines.
Technical specification:
All (100%) filters are leak tested. The tests check the exterior and tightness of the bonnet. All production...
• Ductile iron body EN-GJS 400-15
• ISO 5211 drive connector (upper ISO flange)
• Three plain bearings
• Special form of loose shaft lining with shaft crossing
• Product designation in accordance with: EN 19, EN 1171
• Stainless steel shaft 1.4021 (not attached) with bottom mounted in blind hole in body
• Terminal connection according to EN 1092-2 (DIN 2501), pressure PN10, PN16
•...
Made of ductile cast iron EN-GJS 400-15, the possibility of shortening the mounting surface area. Galvanized steel squere section 18mm. Ductile cast iron EN-GJS 400-15 coupling mounted on the valve spindle with the split cotter. Extension spindle liner cap pipe bell and thrust washer made of PE. Pipe bell protects against dirt penetration from the ground.
error Your review appreciation cannot be sent