

Dimensions (Ø)
48x50
60x60
80x80
100x100
120x120
150x150
Trusted client
Trusted delivery
16 other products in the same category:
- Operating temperature: -10°C to +70°C - Available diameters (dimensions): - DN50 [mm] for Type 6626 valves - Maximum medium flow rate: - liquid: max. 4 [m/s] - nominal pressure ratings (PN): - 1.0 MPa - 1.6 MPa Valves for gravity flow systems. The valve features a cast iron body that houses a loose ball inside (the closure). The body chamber is closed from the top by a cast-iron cover that...
Range: from DN110 to DN1000. MATERIALS: Body, Flap: PEHD Hinge, ribs: Stainless steel 1.4301 (or any other depending on customer requirements). Gaskets: EPDM (or other material depending on working conditions, e.g. NBR, VITON or silicone). Fasteners: A2 (or A4 if required) MOUNTING: Flaps are installed depending on the selected type: - to the wall through the holes in the adapter using...
Available in DN 100, 110, 125, 160 and 200, the valve is comprised of: a recyclable 20% glass fibre reinforced Polyamide body (PA6-20FCV) a recyclable 30% glass-ball reinforced PPH door a TPE lip seal over-moulded on the door to guarantee a seal at a low level of back pressure an over-moulded TPE pipe sleeve seal. Thanks to its material, the flap valve offers good resistance against corrosion...
Range: from DN50 to DN300. - Knife Gate Valve on/off or regulation with rising stem. - Molded monobloc body - Unidirectional water tightness: Flow direction indicated on the body with an arrow. - Installation between flanges ISO PN10. - Small retention zone. - Gate with a beveled cutting edge guided in the body with little backlash. - Guaranteed closure, without risk of blockage. - Standard...
Function ON/OFF or regulation. Wafer threaded mounting ISO PN10. Unidirectional tightness, direction indication thanks to the arrow on the body. Small retention zone: the gate is guided in the body and has little clearance. Gland assembly: packing and O-ring (same material as seat joint) to assure the elasticity and decrease the operating force. Small head loss. Possibility to regulate thick...
MATERIALS: Frame, handle: Stainless steel AISI 304/304L - 1.4301/1.4307 or acid-resistant AISI 316/316L - 1.4401/1.4404 or any other depending on customer requirements Shut-off plate: PEHD (High Density Polyethylene). Gaskets: EPDM (or other material depending on working conditions, e.g. NBR, VITON or silicone). TIGHTNESS: The penstock is tight up to its height It is possible to make penstocks...
GENERAL CHARACTERISTICS Range : from DN 50 to DN 600 Function ON/OFF or regulation Wafer threaded mounting ISO PN10 Unidirectional tightness, direction indication thanks to the arrow on the body Small retention zone: the gate is guided in the body and has little clearance Gland assembly: packing and O-ring (same materials as seat joint) to assure the elasticity and decrease the operating...
error Your review appreciation cannot be sent