16 other products in the same category:
Range: from DN200 to DN1500.
-Body and plate in polyester resin reinforced with glass fibers.
-Low mass structure with minimum face to face
-Easy and quick instauration
-Low pressure drop.
-Installation at the end of the networks on a vertical wall or a standard flange.
-Perfect seal ensured wih gasket conforming to standard NF EN681-1.
Product advantage:
-Low weight for high pressure...
Range: from DN50 to DN300.
- Knife Gate Valve on/off or regulation with rising stem.
- Molded monobloc body
- Unidirectional water tightness: Flow direction indicated on the body with an arrow.
- Installation between flanges ISO PN10.
- Small retention zone.
- Gate with a beveled cutting edge guided in the body with little backlash.
- Guaranteed closure, without risk of blockage.
- Standard...
The materials from which the MULTI valves are made make the parts far lighter than the traditional valves as well as quick and easy to handle and install.
They are very highly resistant to corrosion, UV light, thermal shocks and mechanical stress.
The MULTI valve body is made from glass fibre reinforced isophtal acid polyester and coated in an isophtal acid Gel-Coat.
The axle is ERTACETAL...
Check valve offers a feed-through flow rate of 5,000 l/h (for concrete basins/tanks - 4000l/h for geomembrane basins) for a pressure loss (groundwater pressure or gas pressure needed for opening the valve) of 60 mbar (60 mm head).
Range: from DN50 to DN300.
- Knife Gate Valve on/off or regulation with rising stem.
- Molded monobloc body
- Unidirectional water tightness: Flow direction indicated on the body with an arrow.
- Installation between flanges ISO PN10.
- Small retention zone.
- Gate with a beveled cutting edge guided in the body with little backlash.
- Guaranteed closure, without risk of blockage.
- Standard...
Range: DN50 to DN600.
- Knife Gate Valve on/off or regulation with rising stem.
- Molded monobloc body
-Unidirectional water tightness: Flow direction indicated on the body with an arrow.
- Installation between flanges ISO PN10.
- Small retention zone.
- Gate with a beveled cutting edge guided in the body with little backlash.
- Guaranteed closure, without risk of blockage.
- Standard polished...
error Your review appreciation cannot be sent