Elbow 45° and 90° made of black steel, welding, type F

Hand penstocks, HDPE

MATERIALS: Frame, handle: Stainless steel AISI 304/304L - 1.4301/1.4307 or acid-resistant AISI 316/316L - 1.4401/1.4404 or any other depending on customer requirements Shut-off plate: PEHD (High Density Polyethylene). Gaskets: EPDM (or other material depending on working conditions, e.g. NBR, VITON or silicone). TIGHTNESS: The penstock is tight up to its height It is possible to make penstocks...

Galvanized male coupling with hose tail Typ F

Penstocks, HDPE

MATERIALS: Frame and ribs: Stainless steel AISI 304/304L - 1.4301/1.4307 or acid resistant AISI 316/316L - 1.4401/1.4404 or any other depending on customer requirements Shut-off plate: PEHD (High Density Polyethylene). Gaskets: EPDM (or other material depending on working conditions, e.g. NBR, VITON or silicone). Spindle: A2 or A4 stainless steel. TIGHTNESS: The penstock is tight up to 3m of...

Galvanized female coupling with hose tail Typ F

Flat HydroFlap Non-Return Flaps, Inox

MATERIALS: Body, flap and hinge: Stainless steel AISI 304/304L - 1.4301/1.4307 or acid-resistant AISI 316/316L - 1.4401/1.4404 or any other depending on customer requirements. Gaskets: EPDM (or other material depending on working conditions, e.g. NBR, VITON or silicone). MOUNTING: Flap valves are mounted on a flat wall using anchors. It is recommended to use adhesive anchors. Sealing to the...

Black steel male end plug Typ F

Electrolytic galvanized male coupling with female...

Tank floor check valve

Check valve offers a feed-through flow rate of 5,000 l/h (for concrete basins/tanks - 4000l/h for geomembrane basins) for a pressure loss (groundwater pressure or gas pressure needed for opening the valve) of 60 mbar (60 mm head).

Electrolytic galvanized female coupling with female...

THREADED BALL CHECK VALVE

Galvanized male coupling with male thread, Type F

Galvanized elbow 90° with coupling and pipe...

Galvanized female coupling with male thread, Type F

Knife gate valve with lever stainless steel body -...

Range: from DN50 to DN300. - Knife Gate Valve on/off or regulation with rising stem. - Molded monobloc body - Unidirectional water tightness: Flow direction indicated on the body with an arrow. - Installation between flanges ISO PN10. - Small retention zone. - Gate with a beveled cutting edge guided in the body with little backlash. - Guaranteed closure, without risk of blockage. - Standard...

Galvanized elbow 45° and 90° with couplings, type F

Ductile iron rising-stem knife gate valve with...

Range: from DN50 to DN600. - Knife Gate Valve on/off or regulation with rising stem. - Molded monobloc body - Unidirectional water tightness: Flow direction indicated on the body with an arrow. - Installation between flanges ISO PN10. - Small retention zone. - Gate with a beveled cutting edge guided in the body with little backlash. - Guaranteed closure, without risk of blockage. - Standard...