Odzračni ventil dvojno delujoč za umazano vodo (kanalizacijo, črpališča) PL7020
Trusted client
Trusted delivery
PL7020-0050-5N16
No customer reviews for the moment.
16 other products in the same category:
Flap valve made of HDPE
Range: from DN110 to DN1000. MATERIALS: Body, Flap: PEHD Hinge, ribs: Stainless steel 1.4301 (or any other depending on customer requirements). Gaskets: EPDM (or other material depending on working conditions, e.g. NBR, VITON or silicone). Fasteners: A2 (or A4 if required) MOUNTING: Flaps are installed depending on the selected type: - to the wall through the holes in the adapter using...
Knife gate valve with handwheel stainless steel body...
Function ON/OFF or regulation. Wafer threaded mounting ISO PN10. Unidirectional tightness, direction indication thanks to the arrow on the body. Small retention zone: the gate is guided in the body and has little clearance. Gland assembly: packing and O-ring (same material as seat joint) to assure the elasticity and decrease the operating torque. Small head loss. Possibility to regulate thick...
Flap valve made of polyamide "N"
Available in DN 100, 110, 125, 160 and 200, the valve is comprised of: a recyclable 20% glass fibre reinforced Polyamide body (PA6-20FCV) a recyclable 30% glass-ball reinforced PPH door a TPE lip seal over-moulded on the door to guarantee a seal at a low level of back pressure an over-moulded TPE pipe sleeve seal. Thanks to its material, the flap valve offers good resistance against corrosion...
Penstock stainless steel 316, model PLVGM6206
Most common use: - When transporting sewage and other inert liquids in sewage treatment plants. - Sewage pumping stations, reclamation and hydrotechnical facilities, - Road water drainage systems, flood protection systems. Features: - Material: Body: Stainless steel AISI 316 Knife: Inox AISI 316 - Sealing: 4 sides - Seal: EPDM - Pressure: 6 Wc
Tank floor check valve
Check valve offers a feed-through flow rate of 5,000 l/h (for concrete basins/tanks - 4000l/h for geomembrane basins) for a pressure loss (groundwater pressure or gas pressure needed for opening the valve) of 60 mbar (60 mm head).
Knife gate valve with lever ductile iron body -...
Range: from DN50 to DN300. - Knife Gate Valve on/off or regulation with rising stem. - Molded monobloc body - Unidirectional water tightness: Flow direction indicated on the body with an arrow. - Installation between flanges ISO PN10. - Small retention zone. - Gate with a beveled cutting edge guided in the body with little backlash. - Guaranteed closure, without risk of blockage. - Standard...
Knife gate valve with handwheel rising stem...
Range: DN50 to DN600. - Knife Gate Valve on/off or regulation with rising stem. - Molded monobloc body -Unidirectional water tightness: Flow direction indicated on the body with an arrow. - Installation between flanges ISO PN10. - Small retention zone. - Gate with a beveled cutting edge guided in the body with little backlash. - Guaranteed closure, without risk of blockage. - Standard polished...
error Your review appreciation cannot be sent